A Montclair customer need their door hardware updated.
We removed the old hardware, sanded down the door and installed the new hardware.
We used Baldwin Cody Full Knob Handleset in satin black. We also put in a Baldwin knocker, mail slot, and deadbolt, also in satin 
black.
Install new Schlage sectional handleset In Cedar Grove, NJ
This was a Camelot handleset in antique brass.
A Montclair resident wanted two keypad dead bolts installed. We put in one Schlage BE365, and one Schlage Connect touch screen deadbolt in bright brass as pictured.
A referred customer in Upper Montclair,
NJ need new hardware on their door.
We recommended Baldwin Cody Full Knob
Escutheon in Venetian bronze.
We also replaced her mail slot with Baldwin in the same finish.
What is pictured is a three point lock. One picture the lock is out of the door, and the other, installed in the door.
They run from from the top to the bottom of the door. They are most standard on Pella,
Andersen, and Marvin doors. 
Although many other manufacturers use them also.
This job was in Caldwell, NJ.
We were installing hardware on a whole house in Montclair. They had an unusual set of French doors, very tall but no room for locks in the normal spot. We took the door down, and installed the lock in the bottom of the door. The lock bolt locks into the sill plate. We used a Schlage B560 in 613 dark bronze finish.
A customer in Demarest needed pocket door mortise locks installed. They are complicated installs with many steps.
We install them on a regular basis.
These are Benson polished chrome, low profile, classic rolled edge.
A long time customer in Caldwell called.Her lock was malfunctioning. Although what is lying on the ground is not familiar to most “multi point locks” are much more common
on residential doors. We service Andersen, Marvin, and Pella. As well as european brands. These locks run the full height of the door, top to bottom.
A Montclair customer had us install two smart locks. The one pictured was a Schlage Connect, BE 468 Z Wave smart lock in polished brass.
A customer in Cedar Grove called, their handle set was broken. The trick when replacing it is to not have to drill new holes
In the door, when the door is fiberglass or metal clad. It leaves messy holes that are hard to cover. We installed a Schlage Camelot handleset in antique brass, covering all old holes.